Hello Everyone,
I hope that someone can help me.
The picture that i have add, shows a pin/connector alone. That pin when connected it start to trips the junction board. When I disconnect, the machine turns on again but nothing can be done.
After a while, I am able to connect that pin again and the machine starts working fine, but then it trips the junction board again in some programs after a few minutes. If is just a drain and spin, is fine. If I put on super speed cycle, gets stuck on 37 min.
If I put on a super eco wash, starts to work and trips the junction board again on 57 minutes.
To mention that the heating element is disconnect and I even disconnect the bubble pump.
Motors are working fine as well and even with a new board, it does the same.
I have check for a lose wire or earth wire on the lose but nothing...
Just didn't change yet the control panel yet.
I changed the noise filter, the door lock and didn't help.
Please help! Getting annoyed.
@Members_WwGU0b4: I'm sorry to hear that you're experiencing power issues with your washing machine. Please note that we do not encourage Community members to attempt DIY repairs on their devices, as this can be dangerous. For further information on our policy regarding unorthodox repairs, please refer to the link below.
If you are experiencing persistent power issues with your washing machine then I recommend arranging for the machine to be inspected by one of our authorised engineers, as this will ensure that the correct parts are used, and the device is returned to its factory specifications. To arrange an inspection online, please follow the link below.
