M4rk0
First Poster
15-01-2021 11:09 AM
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
Powerbot R7040 keep showing C 14. However it seems to work just fine.
How can I remove the C 14? I tried to clean up all the sensors. Problem still persists
Samsung:C14
camera's calibration.
Make sure the top window, cameras, and sensors are clean and clear. Using the emergency switch on the bottom of the vacuum, power cycle the vacuum by turning it off for two minutes and then turning it back on.
1 REPLY 1
C 14
First Poster
01-02-2021 04:17 PM
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
Same issue, I have done everything they say and it still shows C 14 but won’t even run.
