MC28M6075CS Microwave Oven, semi-responsive buttons

[Mishima]

Hi, this microwave is coming up to 3 years (guarantee only covered 2 years) of use and some of the buttons seem to be responsive only under certain conditions.

• The START/+30S button only turns on the microwave with 30s on the timer if ECO mode is activated first. Pressing it to add 30S once the microwave is on works as normal.
• Slim Fry only responds if ECO mode activated first.
• Dough Proof/Yoghurt responds, but unable to activate any of the functions with the START/+30S button.
• The other functions are working and responding fine majority of the time, or after ECO mode is activated

Things I've tried so far:

• Turning the Child Lock on and off again.
• Shutting off the power, unplugging and leaving it alone for 10mins (attempted twice).
• Wiping down the inside, door hinges, latches and control panel.
• Used a blunt needle around the edges of STOP and START button in case of debris

Any suggestions or help appreciated!

[notyetfamousUK]

i'm having exact same problems to the letter!

[AntL]

Same problem here, to the letter. Did anyone found a solution ?

[AntL]

.

[AntL]

.

[1947pgs]

I'm having the same problem with the 30 second button, have you been given any solution?

[ElDuKe]

We have the MC28M6055CK and this issue has just started happening with ours.
Havent tested the other issues you mention...

• The START/+30S button only turns on the microwave with 30s on the timer if ECO mode is activated first. Pressing it to add 30S once the microwave is on works as normal.

[1947pgs]

Fortunately our microwave was still under warranty.  Spoke to Samsung helpline (in Korea? but UK telephone number) and engineer came and replaced the control panel assembly and we have a fully functioning microwave again! 😊

[barthoum47]

I've got a similar problem

The start button don't work anymore but it beep when you push it. Specific programm can't be launched

That problem comes whit a default on the display pannel... the problems comes after two or three years. 

You can fix this but  you should be very careful, i decline all responsability....

First :

- disconnect your micro wave and wait  2-3 hours.

- open it there is 5 screw on the back , one to  the side

-  follow  that video:

https://www.youtube.com/watch?v=NXqLvLXlkp4

There is two screw for the command panel (one at the top and one to the left).

Take a picture of all the wire because you wil have to plug them back at the right place

you can dismantle the panel by pulling it up

-  follow  that video:

https://www.youtube.com/watch?v=NXqLvLXlkp4

cutting one of the wire of the display fix the problem. but the display will have a "black hole"