Hey there,
Recently got a Samsung phone and I'm really impressed by some of the OneUI features like routines. I'd really love to use them more often as they have huge potential but I'm realizing that the lack of conditions and actions makes it hard to do quite a lot of potentially useful things.
Conditions:
- Read Sensor data (brightness, tilt, microphone (noise level) and compare it to a value
- Read Brightness and Volume (e.g. for applying a custom EQ profile depending on the volume since higher frequencies travel further)
- Read media playback status (the current "Media being played" condition doesn't pick up my media player at all and yet I can toggle the playback status via the flimsy button on my headphones)
- Read buttons (volume controls, side button, top button, xcover button - I'd love to pause and resume playback via the top button on my phone)
Actions
- Wait for a condition (About this: I like the battery protection feature but 80% of maximum SOC is a bit too low for me, so I added a routine to disable battery protection until the battery reaches 90% at which point battery protection is enabled. This leads to the phone discharging 1% and then recharging that over and over again which I don't think is too good for the battery. I'd like to have it wait for e.g. a charge level of 70% before it starts charging again)
- Control charge behavior (if it charges the battery or not, either one could still accept power from the charger to run the phone directly in case the routine causes the battery to fully discharge and not charge again)
- Media controls (pause, play)
- lock the screen (e.g. when the accelerometer detects a high acceleration it could lock the phone as an anti-theft measure)
- set notification LED color and mode (blink, steady, off)
Any chance that we could get these?
Thanks!
(If anything more comes to my mind, I'll try to put it here. I've only had this phone for two days now)
