Open search
Close search
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- About Kevster
since
16-02-2019
01-10-2019
Kevster
First Poster
4
Posts
0
Likes
0
Solutions
Latest Tags
No tags yet
18-05-2019
10:01 PM
Anyone else unable to get pc passed though there N950? xbox - n950 - q9f no issues Dolby Atmos works and image passed through no problem. However when I try the same via pc - n950 - q9f I get no image or sound even though the pc recognised the connection and ability for Dolby Atmos. If I put the pc direct to the q9f I get image and sound without issue, but Dolby Atmos becomes disabled as far as the pc is concerned because obviously the tv doesn’t support DA. Therefore there is is no issue with my pcs output or hdmi lead as it works fine if the soundbar is bypassed. The issue is the n950 unable to process the signal from the pc correctly. Samsung tech support have been useless so far and it’s been escalated to 2nd line but I’m awaiting a response. Graphics card is Nvidia gtx1070 with the Dolby Atmos app and drivers installed on a windows 10 machine.
... View more
Labels:
06-04-2019
07:53 PM
Still working fine going on 1 and half months now. I only use the arc hdmi 4 port at the tv and only have an Xbox one plugged into the Av receiver.
... View more
16-02-2019
11:54 PM
Trying the following, I’ll report back if it fails by tomorrow. After pulling my hair out trying to get arc working via the tv settings and Av receiver settings I may have come across the solution method in another thread. The other thread referred to a marantz receiver but I applied the idea to my pioneer vsx-932. Any net was enabled on the tv and amp but only digital optical (audio out/opt) was usable and the power up down for both units via the tv remote only worked after unplugging the tv mains for a few minutes. Once this was working I still couldn’t get arc as an option on the tv audio output, just tv speaker or digital optical. next step - select Av receiver as source on Samsung tv, hit “AV ADJUST” on Av receiver remote which brings up a simplified menu unlike the usual GUI on this amp, scroll down to “other” and hit enter, scroll down to sound retrieve and select “ON”. exit this menu and select tv source as tv, Netflix or whatever and you should see the audio output in the smart hub now showing as “receiver”when you check tv settings, no longer audio out/opt. If I’m not mistaken that means the tv is now using ARC correctly. boom! I hope this sticks and doesn’t revert to its usual tv speaker and receiver staying off when I come back to it tomorrow. I’ll let you all know.
... View more