I have a Samsung UE50TU8000 TV with which I've been watching freeview TV through a coaxial cable plugged in the back. I've started experiencing issues recently while doing so.
I indeed get the following error message: "No Signal (1) Check that the cable is plugged in and the settings of the source device are correct. (2) Or, press the SOURCE button below to select a connected source."
I have checked that my aerial cable is indeed plugged in (which it is, albeit somewhat loose). When I unplug it from the back of my TV, I actually get a different error message which reads "Check the aerial cable connection." This makes me think it might not be linked to the cable?
I have tried tuning the channels again but don't find any channels when going through the stops in Settings > Broadcasting > Auto tuning.
Any ideas what this might be?
Solved! Go to Solution.
Not sure if it helps, but the "signal information" section in "Device Care" section is greyed out.
I've also tried auto tuning the channels with a paper clip as an antenna which did not work (no channel found) - that makes me think the issue is linked to the TV rather than the antenna / wiring
So turns out my aerial was dead. Not sure how it just stopped working that suddenly but that's what it is.
I have migrated to using my dish and freesat (had to buy a freesat box).