22-06-2021 07:11 PM - last edited 22-06-2021 07:14 PM
Hi! My husband and I are pretty handy and have done a lot of troubleshooting so far on our own, but we need some help…
Our front loader was on a regular wash cycle and the barrel quit turning with approximately 11 minutes left.
This is what we’ve tried:
-replaced door switch
-replaced hall sensor
-checked the back wiring harness for a break
-checked the rotor and stator physically and the ohms
The pump cycles on and off. There are no obstructions.
We tried to run a cycle again today, and water is not even being drawn in now.
Any ideas? What have we missed?
22-06-2021 07:26 PM - last edited 22-06-2021 08:14 PM
@familymcd: Can you try running a cycle with an empty load, to help determine if the issue is stemming from an imbalanced load? If it doesn't spin, please try gently pressing on each corner of the machine from the top. Does it rock or tip at all? If it does, adjust the feet at the bottom by twisting them anti-clockwise to the desired position, then tighten the locking nut with the supplied spanner to level out the machine to see if this helps.
22-06-2021 07:37 PM - last edited 22-06-2021 07:39 PM
04-07-2021 01:38 AM in
Thank you for your reply. We were on vacation and are now back at trying to figure this machine out…
The machine is level.
We have tried running several empty loads, and it adds water, then spins partially, then stops and gets stuck there. It continues adding small amounts of water, so we stop the cycle and put it in rinse mode. It will evacuate most of the water.
We even installed a new pump today, but nothing has changed.
04-07-2021 01:45 AM in
Thank you for your reply. We have tried all of those things except resetting the breaker. It also mentions not getting enough power will cause it not to spin. We will look into this.