Thanks for providing that info Yolesnoobs,
I got the watch for Xmas so i can only look at the logs after January.
It's good to see it was OK before the update, gives us hope lol.
So I went for a mountain bike ride last night.
Settings I used, workout tracked with the native S-Health workout tracking on the Gear Sport
Cycling Autodetect: Off
Auto HR Settings: Always
Workout Type: Cycling
Target: Basic Workout
Auto Pause: Off
This data looks much better, no flat lines, and I was working pretty hard. This data also resembles what I would get last year on my Gear Fit2. I would like to use the auto pause feature and turn off the HRM mode from always but so far this is the best result I have had, and by no means do I consider this issue resolved. Just more data for Samsung to use to find a fix.
Can more people try those settings, here is mine from yesterday. Now I had rebooted recently and one off good result can happen and it was a very slow and steddy ride due to the heat, but I got a good result.
Shealth(Cycling Autodetect: Off, Auto HR Settings: Always, Workout Type: Cycling, Target: Basic Workout, Auto Pause: Off, Location: On, Started manually)
Only odd thing was the spike to 191bpm Chest HR doesn't have that.
Strava (HR Strap)
This morning I decided to do my dog walk as an 'exercise' rather than auto detect.
When I selected walk from the exercise menu the HR just showed 2 dashes,so I went to the HR widget and made sure it was reading,then went back to the exercise selection and the HR was showing number positive!!
As you can see,I had a good HR reading throughout my walk.
So as you can see from the second chart, I didn't lose any HR data separate from the exercise data too.
Auto detect on
Auto pause on
The Auto pause kicked in on numerous occasions, due to dog walking 'jobs' and hasn't seemed to affect the HR reading.
Will go for a run tomorrow morning,too hot now, and report back.
We'll see how it copes with more or less the same settings but a much higher heart rate, hopefully
I had a much more successful outcome this morning on my run......
So I had it set as follows...
Auto detect on
Auto Pause on (although I didn't stop 😁)
I went to the exercise selection and chose running,at the top next to the location market the HR showed -- so I exited that and went to the HR widget and made sure it was reading as a beat by beat - ie some variety and said 'NOW' as below......
Then I went back into the exercise menu and selected running again and once the location had detected I also had a heart rate figure instead of 2 dashes, as below.....
Obviously i recreated the process once I knew it had been successful!
Will keep on like this for now,using s.health, as it's very annoying having to remember to turn auto detect for walking and running on and off all the time.
Hope this helps
I had same problem. Only solution so far has been to change the settings to:-
Auto pause Off
The auto pause appears to be the main problem in this software. None of this is satisfactory an Samsung should fix this unless they are planning to move Android OS for the watch!.
Hope this helps everyone
BBred I have left my auto pause on and when i did a walk this week it activated on numerous occasions as I was walking the dogs.
I had no interruptions on my HR for that, if you see from my earlier post from Friday.
For me, if you make sure the HR is picking up before you start the exercise, As per my post yesterday, it seems to work, so far.
Ricky, I agree, we shouldn't have to faff about like this. However,it's a pretty agreeable process compared to what I used to have to do with my fitbit to ensure GPRS connection with my phone!